This Snapper any good? Value?
I need something that will handle 3 acres. The area is mostly flat with obstacles. there are a few slopes but not very bad can be cut horizontally instead of vertical. My price range is used-$2500, new...
View Articlemower wont cut thick grass chokes sputters black smoke right side exaust.
I have cleaned carb changed air filter and replaced plugs no results can anyone advise I have john deere 316 with gx 670 Honda 24 hp twin
View Article10323 engine the same as the commercial model LB
Is the engine on my 10323 (6.5 Duraforce) the same engine as the ones L.B. used on their commercial models? Jeff
View ArticleClik here to view.
Echo Trade Up And Save Event
Deals: Buy Any ECHO Bear Cat 3" Chipper/Shredder And Receive A ECHO PB-250LN Blower FREE: ECHO Bear Cat | Special Promotions Save $10 on the lightweight, low noise PB-250LN Blower (w/ rebate):...
View ArticleCharging fuse starting to blow
Ok, I have replaced the battery, stator and flywheel this week and everything went well. Engine fired right up and the volt meter indicated it was charging. I took the mower out and was driving to the...
View Articlecheck engine light
I have a 2002 walker riding mower 26hp efi with less than 1000 hours. Mower ran fine and recently wont start after finished mowing when engine is still warm. Changed both relays and no change. Now...
View ArticleClik here to view.
Repairs hr215 SXA masters transmission
Bought this used and figured would need to replace tranny. Have uploaded pictures. not sure what happened , but appears wheel adjuster arm became defective and somehow scored the axle whereby it...
View ArticleBest buy for 2 1/2 acre mowing ?
I've posted this in TractorByNet.com - Compact Tractor Forum by mistake as well. After a while I will remove it from there. Hello. I have been mowing my hilly, bumpy uneven 2.5 acres with my troybilt...
View Articlewanted Briggs & stratton 28s777 1142-e1 14hp 1999 vintage
I'm looking for a B & S intek 28S777 engine for a White LT14. the engine I have was on fire and burned the intake and some wiring but still turns over with good compression. what I'm looking for is...
View ArticleWanting to Sell Dad's Gravely
Hello ~ I hope I'm on the correct board here. I need some information concerning my Dad's gravely. Dad is 90 and no longer is able to cut grass. A distant neighbor approached my sister (who cares for...
View Articlesimplicity sunstar engine question
I have sunstar that I am repowering with a 18hp briggs. I do not have the original 18hp kohler and I need to know the distance from the center of the crank to the base of the engine. If it possible for...
View Articlemower wont cut thick grass.backfires black smoke smells rich
I have john deere 316 with Honda gx 670 runs fine until under load .cleaned carb changed air filter changed plugs no change.anyone have advise
View ArticleExcel invoice template needed
Probably a long shot, but was wondering if anyone had a simple hourly invoice template for excel. I am doing some side work (tree/bush trimming and planting) and lack the knowledge on excel to develop...
View ArticleClik here to view.
Older John Deere/Bunton Walk Behind Drive Belt Question HELP!
Hi Guys, I just picked up an old (1987 I believe) John Deere 36" walk behind. I've been restoring it and pretty much have it going except for one issue: the tensioner for the drive belt (motor shaft to...
View Articlekohler ch25 (AND OTHERS) BREATHER REED
this is a general kohler question. does anyone know where the breather reed valve is located, and how to service/replace on kohler ch25s engine? I suspect it is located under the metal shroud/baffle...
View ArticleClik here to view.
1994 HR215 SX - OEM Fuel Line and Breather Tube, Replace or Not?
I have never replaced the rubber OEM fuel line or rubber breather tube. The twenty year old mower runs like she did 20 years ago but you'd think after this amount of time the ethanol would play a...
View ArticleClik here to view.
Snapper 21351pd
Today was my lucky day found this In a back yard of one of my HUD homes. Only thing missing is the chute. image-310923336.png (( cowboy up and get over it )) Attached Images image-310923336.png (2.03...
View ArticleLawn Boy year model confusion
Hello guys, Today I bought a vintage Lawn boy mower and I want to use it because it's small and lightweight, and I just like tinkering with old stuff. It has a tag with "Model number 3057, and serial...
View ArticleWon't run with air filter on.
I have a Troy-Bilt 4-cycle Backpack Blower and I rebuilt the carb. Since then it will start and run great, alittle fast I think. Untill I put the air filter back on. It is sealed against the block and...
View ArticleJohn Deere GT245, Was Surging, Now Running Wide Open
Hi, I'm new to the forum, but am looking to see if anyone has experienced the same problem. I have a 2005 John Deere GT@$% with the Kawasaki V Twin. It started surging, so I replaced filters, cleaned...
View Article