Wheel Horse Oil Leak
I noticed some smoke coming from the front and after checking found that all around the muffler was wet with oil. What is the best way to find out where the leak is coming from?
View ArticleDYT4000 backfires when running
My Craftsman DYT4000 with the V-twin Briggs and Stratton 24hp engine (445777) backfires all the time when running. Starts OK and runs good for about 30 seconds, but then backfires constantly--unless...
View ArticleCan I make my Hydro Walk Behind go faster?
I have an older 61" Scag Hydro walk-behind. I am wondering if I can make it self propel a bit faster. Is there an adjustment I can make somewhere? Any assistance would be appreciated. Thanks. AJ
View ArticleHRR2163TDA Carb problems.
I have replace and also had the carb replaced by authorized dealer a total of 4 times already this season. A few because it would leak after shutting off mower and now I shut off the fuel lines to the...
View ArticleClik here to view.
Hello
First time posting. Worked on a John Deere Z425 which would not start. Corroded 7.5 amp fuse to the fuel shut off and hour meter was the problem. Fuse good but connections corroded. Own a Gravely...
View ArticleFuel John Deere Z425 No Fuel
Hi, Just worked on a JD Z425 with a no start, no fuel condition. John Deere is using a fuel shut of solenoid on the bottom of the carb that is hard to see but is used in case of tip overs and as a...
View ArticleConnecting two zero turns together??
I have 2 exmarks, one is a 27hp 60" and the other is a 23 hp 50" (i think) Just wondering if any of you have ever hooked two of them together to make a really wide cut? I'm wondering about how to...
View Articlesnapper hi vac with a vibration
Hey guys, I have a Snapper hi vac self propelled mower and I have a vibration problem with the self propelled part of the mower. If I use the mower in one of the first 2 speeds, there is basically no...
View Article21 HP Briggs & Stratton that keep dying on me
"I have a craftsman 21 HP briggs and stratton that started stalling out about one week ago. It runs for a short while and then it seems to run out of gas. I drained the gas tank, cleaned the air filter...
View ArticleScag 61" SSZ neutral switches
Has anyone found a replacement for the 4 terminal EXPENSIVE neutral switches ($40)? I need two. The way the switch works, 2 contacts are closed in 1 position and the other contacts are closed in the...
View ArticleMurray ride on problem
Hi all, I hate to post questions as a first post but this seems to be the best place to help. My father in law has a Murray 10/30 ride on fitted with a Briggs&Stratton 10hp 28a707-0113-01 engine....
View ArticleCraftsman lt1000 riding mower
We just bought a used craftsman lt1000 riding mower. The brakes dont work on it, when you push on the brake pedal, all it does is disengage. It wont stop the mower. Anyone know whats wrong or how to...
View ArticleClik here to view.
Wtb: mtd side discharge chute
Looking to buy a side discharge chute for a 42 inch cut mtd rider. Same as 38 and 46 inch decks. PN 732-1032. Price shipped to 45805. Attached Images image-2795892036.jpg (133.5 KB)
View ArticleBriggs 10 HP in a Murray ride on
Hi all, My father in law has a Murray 10/30 ride on fitted with a Briggs&Stratton 10hp 28a707-0113-01 engine. Normally the unit is fine but a few days ago it suddenly stopped. Cranking the engine...
View ArticleClik here to view.
Mower deck Deep vs shallow deck
Hello all. I have a question I have not been able to find an answer to. I have a 1997 model ranch king with a 42 inch deck. I have heard that this year was the change over year from shallow to deep...
View ArticleGreetings from the Deep South
Hello All: Just wanted to introduce myself, Clay, a dirt repair enthusiast who takes Fleet Maintenance pretty serious. Why? Because if I wasn't tinkering with all this equipment, I'd have to do yard...
View Articlecompression spec??
does anyone know what the compression should be on my 14.5 hp Briggs? its a 1996 briggs model 28N707 0131-01 Thanks for the help!
View ArticleFoam filled tires
Do any of you guys have experience on foam filling tires on a zero turn? I have a ZD326 Kubota and we are constantly fixing tires. I ran them tubeless. Then put in tubes. Both ways we have had...
View ArticleClik here to view.
Front and rear throws....
Let's see some pictures of the old school front and rear throws still out there Attached Images 10380976_770798776283862_6149990036975020379_n.jpg (83.5 KB)...
View Article1999 xw2502-60 Dixie Chopper
Is anyone familiar with the XW2502-60 Quad Loop mower? 60" rigid deck no suspension at all on mower/ Kohler 23 HP motor I purchased one last year when we moved and it ran perfect but after sitting...
View Article