21.5 HP surging problem
I have a 2002 I/C Intex Platinum engine. I have to modulate the engine with the choke when running without the PTO engaged...it runs 99% and when I engage the PTO...she cuts at about 85% but I have to...
View ArticleHusqvarna 775 Ex rear wheel drive lawnmower
Trying to change the belt on my 775 EX Husqvarna I'm having trouble removing the belt from the guides. I have removed the blade and the plastic housing around the blade Is there a way to remove the...
View ArticleTrouble with discharge
I have a 60" deck, 30 hp. Lazer Z. New Blades, and I had the deck powder coated to help with the grass sticking. The grass builds up under the deck until it either stalls, shudders and spits out or I...
View ArticleHustler SD 60" just arrived from Lowe's
While it arrived over a week after the initial estimate, it finally did arrive and I am pleased. I went with the 60 over the 54 because 1) I measured and it fit through everything in my yard, 2) it had...
View ArticleI need help with a grasshopper 928d
I have a grasshopper 928D. The right drive transmission will not back up or doesn't have reverse. My dealer says it needs a new drive transmission, does anyone have any other theories on this. It does...
View ArticleScag Overheating
I have a 61" Turf Tiger with a Kawasaki. I run for about 20 minutes and the temp guage gets within about 1/8" of red. It varies slightly from run to run but consistently I'm in that territory. I...
View ArticleKohler 26 hp Command charging problems
I have a Cub Cadet LT1050 w/26 hp Kohler Command engine and I'm having issues with the electrical system. The battery won't stay charged up when I mow. The battery is new. I took some measurements...
View Article2004 Fastrak w/jerky hydro units
I'm using a Fastrak 52" while my Woods is int the shop. Pretty impressed with the mower. Its more stable on inclines and cuts faster & smoother. Thinking about replacing my Woods with it, but there...
View ArticleRepairs Husky Chain Saw Question
I couldn't find a more appropriate forum for this question, I have a Husqvarna 575XP Chain Saw that will start, but stalls when the throttle is pressed. I removed and cleaned the carburetor and still...
View ArticleRepairs Husky Chain Saw
I couldn't find a more appropriate forum for this question, I have a Husqvarna 575XP Chain Saw that will start, but stalls when the throttle is pressed. I removed and cleaned the carburetor and still...
View ArticleRepairs Chain Saw
I couldn't find a more appropriate forum for this question, I have a Husqvarna 575XP Chain Saw that will start, but stalls when the throttle is pressed. I removed and cleaned the carburetor and still...
View Article12hp I/C surging
hi guys, I have a 12hp I/C briggs in my mower and it idles perfect but at mid to full throttle it hunts or surges when its not under a load. the carb has been thoroughly cleaned emulsion tube and all...
View ArticleEngine F525 PTO Clutch
The bearing on the PTO clutch of my F525 went out. Bought new clutch, but can't keep it tight now. If I use an impact to tighten the bolt, the engine won't turn over. If I loosen it to where the engine...
View Articlekawasaki khs750bc Tremmer.
starts right up, and it works for a while but when you move it sideways. it goes out, Please please give me some advice Thanks
View ArticleClik here to view.
Clik here to view.
Lawnboy Dura Force 6.5hp
My, Lawnboy Dura Force 6.5hp won't start after I have been using it & empty the grass catcher. I pull & pull, take out the spark plug replace it with a new one, most times it won't start I have...
View ArticleBreather hose broke
My breather hose broke . I replaced it but it is now blowing oil and smoke from exhaust and cuts off after 5 seconds every time. HELP?
View Articlewhich spark plug for 4.5 HP engine
Hi, I've been using Champion 6851 but would like to know the correct / best plug for this engine OR what you find works well Thanks
View ArticleAriens jackshaft nut torque
New member, hoping to pick some brains. My father-in-law was given an Ariens YT2548 tractor that needed some work. The guy that had it before beat the hell out of it. Model #936036 Serial #000158....
View ArticleHarmony 2013 tractor mower deck problem
Hello all, After changing the belt on my 2013 mower deck I noticed very little tension on the belt. Checking a diagram, the tension pulley spring was missing. I ordered a new spring, but find it very...
View Article